Skip to content

WorkSafeNB reminds workers to stay safe when removing snow from rooftops


Ensuring excessive snow loads on roofs don’t accumulate to unsafe levels is a requirement under New Brunswick’s Occupational Health and Safety Act.

WorkSafeNB reminds employers and workers to take proper precautions to ensure the safety of those who remove snow from rooftops.

“First, it’s important to know your roof’s load limit,” said Richard Blais, director of compliance and regulatory review with WorkSafeNB. “If you don’t know the load limit, have a civil or structural engineer inspect the roof. The engineer may identify any deficiencies that need repair."

If it’s safe for a person to work from the roof, Blais recommends several precautions.

“Since the greatest hazard faced in removing snow from roofs is the risk of falling, it’s critical to use a fall protection system,” he said.

Employees who will be clearing the snow should be properly trained and understand the fall protection system. Employers must ensure appropriate personal protective equipment is supplied and used, and drop areas must be marked on the ground to prevent access by pedestrians below.

Snow should be cleared in a cross direction to the roof trusses, Blais said, as this will reduce the stress on all the trusses at the same time.

Drifted snow should be removed first. (On multi-level roofs, this will be on the lower roofs).

“It’s important to remove snow evenly from both sides of the roof to avoid concentrating a load in one area,” Blais added. “Completely remove the snow from the roof as you clear it, and avoid compacting snow as you walk on unworked areas.”

If using mechanized equipment on the roof, ensure the employee is familiar with the manufacturer’s instructions for safe use, and that it is not used within 3 metres of the roof edge (only allowed on roofs with a pitch of three in 12 or less).

Planning and discussing the work beforehand is key to identifying hazards and raising awareness between owners, employers and employees.

Add Comment