Z-Gard

October 28, 2015
Z-Gard
MSA’s Z-Gard DS Sensor is designed to detect the presence of carbon monoxide and nitrogen dioxide gases in vehicle storage areas, garages or anywhere else the toxic gases may be found. The electrochemical sensors generate a representative output signal proportional to the calibrated operating range. The sensors are available with two output options a 4-20mA analog output or an addressable RS-485 digital signal. Z-Gard Sensors with RS-485 digital output are specifically designed to operate as a system with any Z-Gard CXII or C 485 Controller. Z-Gard Sensors with 4-20mA can be installed as stand-alone sensors typically integrated with the Z-Gard C Controller or common commercial equipment including PLC, DCS or building automation systems. The sensor status is shown by the green OK LED, indicating proper device operation. The switch drive output can be changed to percentages of full-scale, which can be very useful for testing remote devices that may be connected to the sensor output.

www.msagasdetection.com

Other Gas Detection Products

  • Gas Clip Technologies Simple

    2-year run time

    Gas Clip Technologies’ Multi Gas Clip Simple is a four gas detector that will run for two...
    MSA Ultima

    Ultima X5000

    MSA’s Ultima X5000 Gas Monitor is the future of gas detection for oxygen...
  • Honeywell OELD

    Connect older gas detectors

    Honeywell announced a new Bluetooth-enabled device that brings connectivity to fixed...
    iAssign Beacons

    iAssign Beacons

    Industrial Scientific is pleased to introduce iAssign Beacons. These beacons use...
  • gas detector

    Bluetooth fixed gas detector

    Honeywell has a new Bluetooth-enabled fixed gas detector for commercial...
    Ventis

    Ventis slide-on pump

    Industrial Scientific introduces a new version of the Ventis Slide-on Pump...